Lead Process Engineer

Job Responsibility : 1. PFD DEVELOPMENT

2. P&ID DEVELOPMENT

3. Data sheets and specifications (equipment and instruments, piping special parts)

4. Schedules (equipment list, line list, elec. load list)

5. Inter-Discipline Checks IDC (plot plan, equipment layout, piping model / layout, isometrics,

6. Data sheets of equipment, packages and instruments)

7. Utility Flow Diagrams (UFD’s), Process Safety Diagrams, Material Selection Flow Diagrams (MSD’s), Pressure and Temperature Diagrams (PTD’s) & Utility demand calculation.

8. Mass balance and Heat Balance for process using hysys

9. Checking / preparation of control valves calculation.

10. Trip logic diagram / control Philosophy

11. Preparation of “CAUSE AND EFFECT DIAGRAM (BS-132 / BS-131)” for safe plant shut down.

12. Material Request for Process Equipment.

13. Heat Exchanger design & Sizing

14. Preparing project reports, flow diagrams, layout, equipment specifications etc.

a) Surge analysis calculation.

b) Hydraulic analysis for long distance pipeline

c) Critical line sizing hydraulic and sizing validations.

d) PUMP DESIGN / SIZING / SECLECTION & HYDRAULIC : (CENTRIFUGAL /

e) RECIPROCATING)

f) Pumps hydraulic calculations (NPSHA, NPSHR, SHUT OFF, Power requirement)) calculation npsh

g) Pumps hydraulic checks.

FLARE SYSTEM DESIGN :

1. Complete network design like Basis for design Header network, Relief valve or safety valve sizing, Drum sizing and stack Sizing. (WITH EXAMPLE).

a) Flare & PSV load summary

b) Blow down & Depressurization calculations using Hysys

c) Control philosophy

d) ESD philosophy

2. Flare load / header size reduction by taking appropriate credits as per API- Recommendations.

Required Software : 1) HTRI

2) ASPEN HYSYS

3) Aspen Flare Net

4) Pipenet (standard and transient model) Guide to PIPENET

4) Cost Estimation (via. Software OR HYSYS)

Note : Candidate must have minimum of 5 years in oil and gas only.